Toshiba WX9 ASD, Руководство по установке и эксплуатации

Страница: 36 / 226

24 WX9 ASD Installation and Operation Manual
FP
— The default function of this output terminal is to output a series of pulses at a rate that is a
function of the ASD output frequency (50 mA max. at 1.0 kHz to 43.3 kHz). As the output frequency of
the ASD changes, so does the
FP output pulse rate. This terminal may be programmed to provide an
output pulse rate that is proportional to the magnitude of the user-selected item from Table 11 on pg.
186 . For additional information on this terminal, see parameter F676 .
AM — This output terminal produces an output voltage that is proportional to the output frequency of
the ASD or of the magnitude of the function assigned to this terminal. The available assignments for
this output terminal are listed in
Table 11 on pg. 186 . For additional information on this terminal, see
F670 .
FM
— This output terminal produces an output current or voltage that is proportional to the output
frequency of the ASD or of the magnitude of the function assigned to this terminal. The available
assignments for this output terminal are listed in
Table 11 on pg. 186 . For additional information on this
terminal, see F005 .
FLA — One of two normally open contacts that, under user-defined conditions, connects to FLC . The
FL relay is the Fault Relay by default but may be programmed to any of the items listed in Table 11 on
pg. 186 . For additional information on this terminal, see F132 and Figure 7 .
FLB
— One of two normally closed contacts that, under user-defined conditions, connects to FLC .
FLC — FLC is the common leg of a single-pole double-throw form C relay.
Note: The FLA , FLB , and FLC contacts are rated at 2A/120 VAC and 2A/30 VDC.
Figure 7. FLA, FLB, and FLC switching contacts shown in the normal operating condition.
Note: The relay is shown in the normal operating condition. During
a faulted condition, the relay connection is FLC -to- FLA .