– 13 –
Wireless remote controller
A-B selection
Using 2 wireless remote controllers for the respective air
conditioners, when the 2 air conditioners are closely
installed.
Wireless remote controller B setup
1.
Start the air conditioner.
2.
Point the wireless remote controller at the
indoor unit.
3.
Push and hold
button on the wireless
remote controller by the tip of the pencil.
“00” will be shown on the display.
4.
Push MODE
button during pushing
.
“B” will be shown on the display and “00” will
be disappear and the air conditioner will turn
OFF. The wireless remote controller B is
memorized.
NOTE
•
Repeat above step to reset wireless remote
controller to be A.
•
The wireless remote controllers do not display “A”.
•
The factory default of the wireless remote controllers
is “A”.
•
A-B selection can be set with signal receiving unit.
For the further details, refer to the installation
manual.
9
Operating air conditioner without remote
controller
In the following cases, the air conditioner can be operate without remote controller with temporary operation
button on the signal receiving unit.
•
The battery in the remote controller expired.
•
A trouble occurred on the remote controller.
•
The remote controller has been lost.
1
Start
Push temporary operation button.
•
The operation mode is the one last selected.
If you want to change it, turn the power off and
then on, and push the temporary operation button
again.
2
Stop
Push temporary operation button once more
CHK
CHK
PRESET
FAN
"B" Display
"00" Display
1, 2
13-EN
+00EB01700201.BOOK Page 13 Wednesday, September 28, 2011 10:22 AM
