8
How to use the iron
Steam ironing
1
Temperature settings
z
Steam
z
z
Press the SET / OFF button to set the temperature according to the fabric you are ironing.
The temperature lamp flashes. (See page 7)
According to fabric
z
Shower Steam, Ultra shot, and Hanger shot
z
z
Press the SET / OFF button to set the [HIGH] temperature setting.
The temperature lamp flashes.
If you set any temperature other than [HIGH], water may leak out and Shot may not work.
Shower Steam is for
finishing thick fabrics
or wool
Always in [HIGH]
2
Getting started
You can use the iron when the temperature lamp stops
flashing
and stays
lit
.
(When you take the iron off the stand, the temperature lamp turns off.)
z
z
Set the Steam / Dry lever to [
Steam] or [
Shower].
Attention
z
z
If the iron is set to [LOW] or [MED], always set the Steam / Dry lever to [
Steam].
z
z
If the steam does not come out very well, press the Shot button
several times to do a steam shot.
z
z
If you are ironing a blended fiber, set the temperature according to the lower temperature fiber.
z
z
Drops of water may adhere to the surfaces of the iron and the water tank when steam comes out. Wipe off the drops of water if too
many water drops collect.
Notice
z
z
When you put the iron back on the stand, it may make a hissing noise and steam may come out of the soleplate, but this is not
abnormal. (This is because the water left in the channels within the iron is slowly vaporizing.)
z
z
When you first turn on the power, the iron may emit a slight smell and some smoke, but this will go away as you use it.
Flashing
Lighting
Stays
lit
when it reaches the set temperature.
