Toshiba STRATA CIX DKT2404-UDR100, Руководство по эксплуатации

Страница: 19 / 22

DKT2404-UDR100 DECT Repeater
Trouble Shooting
DKT2404-UDR100 Repeater 04/09
TOSHIBA
13 of 16
• If the product has been exposed to water or rain.
• If the product does not operate normally when following the operating
instructions. Adjust only those controls that are covered by the
operating instructions. Improper adjustment of other controls can
result in damage, and will often require extensive work by a qualified
technician to restore the product to normal operation.
• If the product has been dropped, or the cabinet has been damaged.
• If the product exhibits a distinct change in performance.
Trouble Shooting
Important Electrical
Considerations WARNING! Do not attempt to unplug any appliance during an
electrical storm.
Unplug all electrical appliances when you know an electrical storm is
approaching. Lightning can pass through your household wiring and
damage any device connected to it. This repeater is no exception.
Changes or modifications to this product not expressly approved by
Toshiba America Information Systems, Inc., or operation of this product in
any way other than as detailed by this manual, could void your authority
to operate this product.
Table 2: Trouble Shooting for Users
Problem Solution
There is a lot of static when calls hand-off
to the repeater. AND/OR the LED on the
repeater won’t stop flashing. Move the repeater closer to the base. Check for
interference from electronic devices. Make sure the
repeater is not too close to metal objects or thick walls.
I used to be able to connect to the base,
but now I can’t. Make sure the repeater is powered on. Reset the
repeater and register it to the base again (see
“Registering to a Different Base” on Page 8 ).
When I’m on a call, the handset starts
beeping. Turn off the verification tone, refer to “Verification Tone”
on Page 9 .
Calls won’t hand-off to the repeater. Make sure the repeater is inside the base’s good signal
range. Make sure there is at least 35 feet between
repeaters. Reset the repeater and register it to the base
again (see
“Registering to a Different Base” on Page 8 ).