Toshiba Strata AirLink, Руководство по установке

Страница: 54 / 117

RWIU System Installation
Step 1: Check DIP Switches and Jumpers on PCB
44
Strata AirLink Installation Guide 5/00
1. Check DIP Switch S1. Table 11 gives the factory settings - defaults are in bold.
Important!
●
Switch 8 is used to recover the RWIU in the event of a software load failure. Turn Switch 8
to its off position to force a download of the stored factory default software.
●
If any Base Station is not used, put its corresponding S1 switch in the on (inactive)
position. If the switch is in the off position, the WWIS subassembly LED 1 and 2 remain lit
and the RWIU tries to initialize that Base Station every 40 seconds.
2. Check DIP Switch S2. Table 12 gives factory settings - defaults are in bold:
3. Check DIP Switch S3 settings to ensure that the correct number of handsets are enabled (see
Table 13 ).
4. Verify that the Watch Dog Timer (WDT) is jumpered correctly as shown in Figure 24 .
Table 11 S1 Factory Default Positions
S1 DIP Switch Number
Position 1 2 3 4 5 6 7 8
On
Base
Station 1
Inactive
Base
Station 2
Inactive
Base
Station 3
Inactive
Base
Station 3
Inactive
Spare Spare Spare
Disable
Download
Off
Base
Station 1
Active
Base
Station 2
Active
Base
Station 3
Active
Base
Station 4
Active
Spare Spare Spare
Force
Download
Table 12 S2 Factory Default Positions (RF Signals)
S2 DIP Switch Number
Position 1 2 3 4 5
On Slave
1
1. RWIU must be in the master setting to operate.
DECT
2
Disabled
2. DECT = Digital European Cordless Telecommunications
PCS
3
Disabled
3. PCS = Personal Communication Service
Four Ports Spare
Off Master DECT Enabled PCS Enabled Two Ports Spare
Table 13 S3 Factory Default Positions (Number of Handsets)
S3 DIP Switch Number
Number of
Handsets
1 2
On On 8
Off On 16
On Off 24
Off Off 32