23/28
SD-R6112 Rev.1.0
7.2.7. Peak in executing Access
1,700 mA (DVD/CD)
(Exclude Spike Current)
*Spike: Less than 1 ms of duration
7.2.8. Write
1,000 mA (CD-R 16X)
660 mA (CD-RW 4X)
985 mA (High speed CD-RW 10X)
650 mA (DVD-R 2X)
600 mA (DVD-RW 1X)
8.CD Audio (Test condition: Ordinary temperature)
8.1. Analog Out --- in case of the attenuator is set at 0 dB by the command ---
(1) Output Level
0.8 V (rms) Typ.
(2) Type
Unbalanced
(3) Load Impedance
47 kOHM min
(4) Frequency Response
20 Hz to 20 kHz+/-3.0 dB. (at 47 kOHM Load)
(5) Distortion
0.04 % Max. (at 1 kHz w/20 kHz LPF)
(6) Signal to Noise Ratio
80dB Typ (IEC179 A-Weighted)
8.2. Audio Modes
(1) 16 Modes including 'Stereo', 'Lch Mono', 'Rch Mono' and 'Mute' are selectable by command.
Default mode is 'Stereo'.
(2) 16 Steps of attenuation level for the Audio Output is selectable by command.
Default level is 0 dB.
9. Device Configuration Jumper
9.1. Master Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.
9.2.Slave Mode Setting
Open the PIN 47 of I/O connectors.
(Optional)
9.1. Master Mode Setting
Open the PIN 47 of I/O connectors.
9.2. Slave Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.