9/28
SD-R6112 Rev.1.0
3.3.3.Recommendation:
As for mounting bracket to incorporate this product into an equipment,
(1) When this product is incorporated into an equipment by using the mounting screw holes
in the right and left side planes, the clearance between this product and the mounting
bracket is too wide.
(2) When the surface of the mounting bracket is contorted.
If you use such mounting bracket as the above, this product will become deformed, which may
cause operation failure. Therefore, it is necessary to take account of the mounting bracket
which has the tolerances shown in Fig.3 or whose structure cannot cause this product to
deform, asshown in Fig.4, or adjust the gap to 0.3 mm max. by attatching fittings, such as a
spacer.
(102.6 +0.2/-0.2 mm)
102.8 +0.2/-0 mm
Max. 3.0 mm
Figure 3
When a large amount space is left,
insert spacers, etc. to adjust the space
less than 0.5 mm between the product
and mounting bracket.
Max 0.3 mm
Elastic structure
Spacers, etc.
Figure 4
3.4. Dimension and Mass ----- See Figure 5 for details -----
(1) External Dimensions (W x H x D)
128 mm x 12.7 mm x 126.1 mm (excluding bezel)
(2) Mass
0.2 k
g
(Typ.)
11.9 k
g
(Bulk Packaged 50 pcs)
4.9 k
g
(Bulk Packaged 20 pcs)
