Install Batteries in the Remote control
1
Open the battery
cover on the back of
the remote control.
Operating with the remote control
Point the remote control at the remote sensor and
press the buttons.
Distance : Approx. 7m (23 feet) from the front of the
remote sensor.
Angle : Approx. 30º in each direction of the front of the
remote sensor.
• Do not expose the remote sensor of the DVD video
player to a strong light source such as direct sunlight
or other illumination. If you do so, you may not be
able to opearate the DVD video player via the remote
control.
2
Insert two AA batteries.
Make sure that the
polarities (+ and -) are
aligned correctly.
3
Replace the battery
cover.
If the remote control doesn’t operate
properly:
- Check the po/- of the batteries (Dry-Cell).
- Check if the batteries are drained.
- Check if remote control sensor is blocked by
obstacles.
- Check if there is any fluorescent lighting nearby.
Caution:
Never throw batteries into a fire.
Notes:
• Be sure to use AA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the
environment in mind. Always dispose of batteries in
accordance with applicable laws and regulations.
• If the remote control does not operate correctly, or if
the operating range becomes reduced, replace
batteries with new ones.
• When necessary to replace batteries in the remote
control, always replace both batteries with new
ones. Never mix battery types or use new and used
batteries in combination.
• Always remove batteries from remote control if they
are dead or if the remote control is not to be used
for an extended period of time. This will prevent
battery acid from leaking into the battery
compartment.
Before you start
Accessories
Remote
Control
Batteries for
Remote Control
(AA Size)
User’s Manual
Video/Audio
Cable
HDMI-HDMI
Cable
ENG-6
Within approx. 7m(23 feet)
30º
30º
Introduction
00873A-SD-6980SY-1 8/22/05 4:41 PM Page 6
