FILE NO. SVM-1
5006
–
53
–
10. INSTALLATION PROCEDURE
10-1. Installation Diagram of Indoor and Outdoor Units
Before installing the wireless remote controller
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (
−
) positions.
3 Batteries
2 Wireless remote controller
Insulate the refrigerant pipes separately
with insulation, not together.
2
3
8
4
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
For the rear left and left piping
Make sure to run the drain hose sloped
downward.
Do not allow the drain hose to get slack.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom
right
Rear
left
Bottom left
Left
6 mm thick heat resisting
polyethylene foam
Batteries
Flat head
wood screw
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Wireless remote control
Saddle
Extension
drain hose
(Not available,
provided by installer)
600 mm or more
100 mm or more
100 mm or more
600 mm or more
600 mm or more
Remark :
• Detail of accessory and installation parts can see in the accessory
sheet.
• Some pictures might be different from the actual parts.
5
Filter
8
Flat head
wood screw
9
6
Flat head
wood screw
Battery cover
The provided Remote Controller is a wireless type,
which also can be used as a wire.
Please see “How to Connect The Remote Controller
for Wired Operation”, in case of wired control is
required.
1
Shield pipe
Air
fi
lter
Hook
Installation
plate
Hook
65 mm or more
170 mm or more
170 mm or more
(Attach to the front panel.)
Wall
Cut the piping
hole sloped
slightly.
