Toshiba MMY-MAP0804FT8-E, Руководство по установке, Страница: 19 / 37

– 18 –
 F-GAS label
This product contains fluorinated greenhouse gases covered by the Kyoto Protocol
• Chemical Name of Gas R410A
• Global Warming Potential (GWP) of Gas 1975
CAUTION
1. Stick the enclosed refrigerant label adjacent to the charging and/or recovering location.
2. Clearly write the charged refrigerant quantity on the refrigerant label using indelible ink. Then, place the included
transparent protective sheet over the label to prevent the writing from rubbing off.
3. Prevent emission of the contained fluorinated greenhouse gas. Ensure that the fluorinated greenhouse gas is
never vented to the atmosphere during installation, service or disposal. When any leakage of the contained
fluorinated greenhouse gas is detected, the leak shall be stopped and repaired as soon as possible.
4. Only qualified service personnel are allowed to access and service this product.
5. Any handling of the fluorinated greenhouse gas in this product, such as when moving the product or recharging
the gas, shall comply under (EC) Regulation No. 842/2006 on certain fluorinated greenhouse gases and any
relevant local legislation.
6. Periodical inspections for refrigerant leaks may be required depending on European or local legislation.
7. Contact dealers, installers, etc., for any questions.
R410A
kg
kg
kg
Pre-charged Refrigerant at Factory [kg],
specified in the nameplate
Additional Charge on Installation Site [kg]
 Heat insulation for pipe
• Apply heat insulation of pipe separately at the liquid, gas, and balance sides.
• Be sure to use heat insulator resistant up to 120 °C or higher for pipes at the gas side.
 Finishing after connecting pipes
• After piping connection work has been finished, cover the opening of the piping / wiring panel with the piping
cover, or fill silicon or putty into the space between the pipes.
• In case of drawing-out the pipes downward or sideward, also close the openings of the base plate and the side
plate.
• Under the opened condition, a problem may be caused due to the entering of water or dust.
◆ Pipe holding bracket
Attach pipe holding brackets following the table below.
When using the piping cover When not using the piping cover
Diameter of pipe (mm) Interval
Ø15.9 - Ø19.1 2 m
Ø22.2 - Ø41.3 3 m
Piping / wiring panel
Drawing-out sideward
Close the opening with the
pipe cover.
Drawing-out
frontward
Drawing-out
downward
Piping / wiring panel
Drawing-out sideward
Fill silicon or putty into the
periphery of the pipes.
Drawing-out
frontward
Drawing-out
downward
35-EN 36-EN