Toshiba MMW-AP0481CHQ-E, Руководство по установке

Страница: 25 / 38

– 24 –
 Wire connection
REQUIREMENT
• Connect the wires matching the terminal numbers. Incorrect connection causes a trouble.
• Pass the wires through the bushing of wire connection holes of the hot water module.
• Keep a margin (Approx. 100 mm) on a wire to hang down the electrical control box at servicing or other purpose.
• The low-voltage circuit is provided for the remote controller. (Do not connect the high-voltage circuit)
• Remove the front panel of the hot water module by taking off the mounting screws (8 positions).
• Wrap a heat insulation (locally procured) around the power supply to fill the gap between cord and port cap.
• Wrap a heat insulation (locally procured) around the control wires and external signal wires to fill the gap between
cord and port cap.
• Tighten the screws of the terminal block, and fix the wires with cord clamp attached to the electrical control box.
(Do not apply tension to the connecting section of the terminal block.)
• Mount the front panel of the hot water module without pinching wires.
Front panel
Heat insulator
(locally procured)
Clamp
Control wiring, External signal wiring port
R
(L)
S
(N)
10
10
30
60
Earth wire
Power supply wire
(Unit: mm)
Power supply
wiring port
Clamp
Terminal cover
R
(L)
S
(N)
U1U2A B COMS1S2S3S4S5
Output signal wires
Remote controller wire
Control wire
Power supply cord
Cord clamp
Earth Screw
 Wiring for Flow selector unit (FS unit) for SHRM-e
Connect communication wire of FS unit to terminal A, B (no polarity) of Hot Water Module,
when the Hot Water Module connects to SHRM-e system.
NOTE
• In case of connecting at least one Hot Water Module in SHRM-e system, all of FS units in the system should be
Single port type FS unit (long piping model) or Multiport type FS unit.
 Remote controller wiring
• Strip off approx. 9 mm the wire to be connected.
▼ Wiring diagram
R
(L)
S
(N)
U1 U2 A B
COM S1 S2 S3 S4S5
Earth Screw
Power supply cord Control wire
Remote controller wire
Communication wire
(Flow selector unit)
A
B A
B
Terminal block
Remote controller unit
Terminal block for
remote controller wiring
of hot water module
Remote controller wire
(Locally procured)
47-EN 48-EN