Toshiba M200 - Portege - Pentium M 1.5 GHz, Руководство по обслуживанию

Страница: 106 / 325

3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
3-6 Portege M200 Maintenance Manual (960-457)
Use the up and down arrow keys to move the cursor to “
ERROR STOP
”.
Use the right and left arrow keys to move the cursor to the option to execute and press Enter .
Selecting
YES
in ERROR STOP stops the test program when an error is occurred and displays
the error status. The operation guide will appear on the right side of the display as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
Press [1] Terminates the test program and returns to the subtest menu.
Press [2] Executes the next test.
Press [3] Restarts the test from the error.
Selecting
NO
in ERROR STOP displays the error status and increases error counter by one if an
error is occurred, and executes the next step.
The sections on and after 3.5 detail the tests of the DIAGNOSTIC TEST MENU. Refer to
Sections 3.21 through 3.26 for detailed information on the remaining Service Program Module
functions.
Table 3-1 in section 3.4 describes the function of each test on the subtest menu. Table 3-4 in
section 3.19 describes the error codes and error status for each error.
3.2.2 H/W initial information setting tool
The following menu appears in the display.
##################################################################
##
#### H/W initial information setting tool VX.XX
####
##################################################################
##
* 1 ............ Initial configuration
*
* 5 ............ Digitizer FM write
*
* 8 ............ System configuration display *
* 9 ............ E2PROM test (MAC/DMI)
*
******************************************************************
*