14
Scan Limits
With any of the scan processes the domes use STOPS. Refer to the proper dome manual to find out more
about this subject.
Using the JK-UC1 to define the STOPS, you have to follow this sequence:
1. Using the Joystick move to the position at which you want to set the STOP.
2. Define if this position is going to be the Right Scan Limit or the Left one.
3. To set the
Right Scan Limit
:
a. Type
down
“
93
” using the number keypad.
b. Press
“
Preset
” The JK-UC1 will display “RLm” on the right display for a moment. After
that, the STOP is set and the displays will go back to show the selected camera number.
4. To set the
Left Scan Limit
:
a. Type
down
“
92
” using the number keypad.
b. Press
“
Preset
” The JK-UC1 will display “LLm” on the right display for a moment. After
that, the Stop is set and the displays will go back to show the selected camera number.
Through out the manual scanning process, the user may be restricted to look at certain
areas. To do so, the Right Manual Scan STOP and the Left Manual Scan STOP must be set.
In that case, follow the next procedure:
1. Using the Joystick move to the position at which you want to set the STOP.
2. Define if this position is going to be the Right Scan Limit or the Left one.
3. To set the
Right Manual Scan Limit
:
c. Type
down
“
91
” using the number keypad.
d. Press
“
Preset
” The JK-UC1 will display “RMLm” on the right display for a moment. After
that, the Stop is settled and the displays goes back to show the selected camera number.
4. To set the
Left Manual Scan Limit
:
e. Type
down
“
90
” using the number keypad.
f. Press
“
Preset
” The JK-UC1 will display “LMLm” on the right display for a moment. After
that, the Stop is settled and the displays goes back to show the selected camera number.
Patterns
Patterns are command sequences that repeat what the user would do in a certain situation. There are two
commands that need to be send to act in this direction:
-
START saving the procedure,
-
STOP saving the procedure.
Start Pattern
g. Type
down
“
266
” using the number keypad.
h. Press
“
Preset
” The JK-UC1 will display “PStr” on the right display for a moment. After
that, the Stop is settled and the displays goes back to show the selected camera number.
End Pattern
i. Type
down
“
267
” using the number keypad.
j. Press
“
Preset
” The JK-UC1 will display “PStp” on the right display for a moment. After
that, the Stop is settled and the displays goes back to show the selected camera number.
Содержание JK-UC1
Страница 1: ...Installation and Operation Manual JK UC1 Universal Controller ...
Страница 8: ...8 Figure 7 ...
Страница 10: ...10 ...