Toshiba GRT100 Series, Инструкция по эксплуатации, Страница: 98 / 270


97

6 F 2 S 0 7 8 9
/ 2 B i n a r y i n p u t 1 = N o r m 2 = I n v 1 / 8
B I S W 1 M e c h a n i c a l t 1 1
B I S W 2 1
B I S W 3 1
r i p
M e c h a n i c a l t 2 r i p
M e c h a n i c a l t 3 r i p
B I S W 4 M e c h a n i c a l t r i 1
B I S W 5 I n d i a c t i o n e r s e t 1
B I S
1
1
1 W 4 E v n e t 1 1
B I S W 5 1
B I S W 6 1
p 4
E v n e t 2
E v n e t 3

Enter 1 (= Normal) or 2 (= Inverted) and press the
ENTER
key for each binary input.
4.2.6.9 Binary Output
All the binary outputs of the GRT100 except the tripping command, and the relay failure signal
are user-configurable. It is possible to assign one signal or up to six ANDing or ORing signals to
one output relay. Available signals are listed in Appendix B.
It is also possible to attach a drop-off delay time of 0.2 seconds to these signals. The drop-off
delay time is disabled by the scheme switch [BOTD].
Appendix D shows the factory default settings.
To configure the binary output signals, do the following:
Selection of output module

Press 8 (= Binary output) on the "Setting (change)" screen to display the "Binary output"
screen. The available output module(s) will be shown. (This differs depending on the relay
model; the following is for Models 102 and 202.)
/ 2 B i n a r y o u t p u t
1 = I O 2 2 = I O 3

Press the number corresponding to the selected output module to display the "Binary output"
screen.
/ 3 B i n a r y o u t p u t ( I O 2 )
S e l e c t B O ( 1 - 1 3 )
S e l e c t N o . =
Note: The setting is required for all the binary outputs. If any of the binary outputs are not to be used,
enter 0 for the logic gates #1 to #6 when assign signals.
Selecting the output relay

Enter the output relay number and press the
ENTER
key to display the "Setting" screen.
/ 4 S e t t i n g ( B O 1 o f I O 2 )
1 = L o g i c g a t e t y p e & d e l a y t i m e r
2 = I n p u t t o l o g i c g a t e