Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 816 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 795 -
Input Output Selection logic in TPOS01
Command
“Local-P3-Control”
TPOS1-P3
ILK
† condition (“P3”) passed
ILK
†
bypassing
1≥
ICB_STATE
[ TPOS01-CTRAHMI ]
SBO
TPOS01 function (Function ID: 513001)
SBO
DIR
&
&
1≥
&
0.1s
0
t
0.6s
0
t
Either
“SBO mode” or “DIR mode”
(e.g.,
“ctlmodel” in IEC61850 *
)
“Automatic sequence control function (AQEQ) § ” in progress
ASEQ_MULTI_SEL
Select condition
‡
“TPOS01_P3SL_BO_FLG”
(513001 _ 8A04011DC8)
Select
“Failed”
To BO connection
Select
“success”
To
“Wait for a command”
Select command
with ILK
†
condition
Operat command
with ILK
†
condition
For SBO operation
For DIR operation
Figure 4.9-13 Select ‘P3-control’ on the front panel in TPOS01 ††
†Note: The ILK function provides the operation criteria for “P3-control”.
††
Note: To identify the input/output signals of the other TPOS logics, see Table
4.9-6,Table 4.9-7 , and Table 4.9-10.
‡Note: A “select condition” signal is provided from the select condition scheme. For more
information, see Figure 4.9-20.
§Note: An automatic sequence control (ASEQ) function can provide sequential signals for
automatic control. The TPOS01 operation is blocked for the ASEQ function when
it is in operation. For more information regarding the ASEQ function, see Chapter
Control and monitoring application: Automatic sequence control function.
Output signal to BO
When the “select condition” signal is true, the TPOS01 function can issue a “Select success”
signal at the output-point “TPOS01_P3SL_BO_FLG”.
1
Note: The “TPOS01_P3SL_BO_FLG” signal is the same signal as shown in Figure 4.9-7.
If the “Local-P3-Control” signal is not true, the TPOS01 function returns to the
“Wait for a command” stage.
(vii)
Receiving “Select command P1-control” by PLC function
Figure 4.9-14 outlines the reception of the select command ‘P1-control’ by the PLC function.