Toshiba FT-8808, Руководство по обслуживанию

Страница: 5 / 67

— 4 —
Test Mode For Handset Unit
To perform the TEST mode, turn the power ON by pressing the “ ” and “#” buttons at the same time.
When entered the TEST mode, the bell rings and the unit enters TEST mode 1 . ( Refer to the following table. )
1. To change the TEST mode: Press the number key for the corresponding TEST mode.
(Refer to the following table)
2. To change channel: Press “CHANNEL” key.
( Note: If the step is changed, the channel returns to the start channel. )
3. To cancel the TEST mode: Turn the power OFF, charge the Handset, press the “TALK” key.
*A : Squelch ON: H Squelch OFF: L
*1 : In TEST mode 3, “0000...” is output continuously as transmitting data.
*2 : In TEST mode 6, bell (1kHz) rings lowly when the data received is “0000...”.
*3 : In TEST mode 7, bell rings loudly with initial 2 tone (2kHz, 2.2kHz).
*4 : In TEST mode 8, bell (1kHz) rings lowly when P BATLOW is “L”.
*5 : In TEST mode 9, bell rings lowly when P CHRGIN is “L”.
Channel rotation
21
→
20
→
19
→
40
→
1
→
2
→
3
→
4
→
5 . . . . . . . 37
→
38
→
39
→
40
→
STEP FUNCTION KEY START CH TX PWR RL PWR TX MUTE RX MUTE CONV REMARKS
1 VCO/TX FREQ. ADJ 1 21 L H L L H
2 TX MOD. CHECK 2 21 L H H L L
3 TX DATA 3 21 L H L L L
*1
4 RX SENS 4 21 H H L H L
5 SQ SENS 5 21 L H L *A L
6 RECEIVE DATA CHECK 6 21 L H L L H
*2
7 BELL 7 21 H L L L H
*3
8 BATTERY LOW CHECK 8 21 H L L L H
*4
9 CHARGE CHECK 9 21 H L L L H
*5
10 DUPLEX 0 21 L H H H L