Installation for Wireless interface.
1. Open cover of Wireless interface and make hole for wire out.
Make hole by tooling,
should no sharp edge
beware wire damage
Open cover
Wire out position
2. Fix on wall or partition following
fi
xing position, connect wire between Wireless interface and Hydro unit.
Hydro unit
2 core shielded cable – 0.5 mm
2
or more.
Maximum cable length – 50 m
Non polar
Screw
fi
xing position
Terminal block CN01
Terminal block TB04, for remote
controller or Wireless I/F adapter
connection, to Hydro unit.
Hydro unit
Wireless interface
Wireless interface
3. Close cover of Wireless interface
Hydro unit
Wireless interface
Note :
1. Be sure no electrical power before installing this
product.
2. Wireless interface must not be installed in areas as
below
- Direct sunlight or areas exposed to outside
air in
fl
uences
- Poor ventilation (near windows or other openings)
- External heat sources (above radiators etc.)
- Freezing or refrigerated areas
- Do not install nearly device the can produce
electrical noise such as elevators, automatic door
and etc.
3. Do not modify for any electrical part, it can cause for
malfunction, electric shock or
fi
re.
4. Install area should be covered by Wi-Fi signal from
Router.
5. Wireless interface compatible with router 2.4GHz
band IEEE802.11 b/g/n standard.
6. Installation level should be 100 mm or more from
fl
oor.
7. Operating temperature should not over 55°C.
BOOK_OM_1130492401-1.indd 2
BOOK_OM_1130492401-1.indd 2
23/11/2564 BE 14:44
23/11/2564 BE 14:44