E-4
4. Turn the Locking Ring counter clockwise and remove the Supply Holder from the Supply Shaft.
5. Put the media on the Supply Shaft.
6. Pass the media around the Guide Shaft, then pull the media towards the front of the printer.
7. Align the projection of the Supply Holder with the groove of the Supply Shaft, and push the
Supply Holder against the media until the media is held firmly in place. This will centre the
media automatically.
Then turn the Locking Ring clockwise to secure the Supply Holder.
NOTES:
1. When the Head Lever is turned to
FREE
position, the Print Head is raised.
2. To enable printing the Head Lever must be set to the
Position1 /
Position2. (This ensures that the Print
Head is closed.)
There are two head pressure levels . Set the Head Lever depending on the media type:
Position
Position2
:Labels
Position
Position1
: Tags
However, proper position may differ depending on media. For details, refer to your TOSHIBA TEC
authorised service representative.
3. Do not turn the Locking Ring counter-clockwise too far or it may come off the Supply Holder.
Locking Ring
Supply Shaft
Supply Holder
NOTE:
Do not over-tighten the Locking Ring of the Supply Holder.
Projection
Locking Ring
Supply Holder
Guide Shaft
Groove
Supply Shaft
