E-6
Media Outlet
Loading with peel off module
When the optional Peel-off Module is fitted, the backing paper is automatically removed from the
label at the Strip Plate as each label is printed.
(1) Remove enough labels from the leading edge of the media to leave 500mm of backing paper
free.
(2) Insert the backing paper under the Strip Plate.
(3) Wind the backing paper onto the Take-up Spool and fix it in position with the Take-up Clip.
(Wind the paper counterclockwise around the spool as this is the direction it rotates.)
(4) Rotate the Take-up Spool counter-clockwise a few times to remove any slack in the backing
paper.
(5) Set the Selection Switch mounted on the Rewinder Assembly to
STANDARD/PEEL OFF
position.
Loading with cutter
When the optional Cutter Module is fitted, the media is automatically cut. A
disc
cutter
and a rotary
cutter are available as an option, but they are used in the same way.
Insert the leading edge of the media into the
cutter until it comes out the Media Outlet of
the Cutter Module.
WARNING!
The cutter is sharp, so care must be taken not to injure yourself when handling the cutter.
CAUTION!
1. Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the
cutter which may affect the cutter quality and shorten the cutter life.
2. Use of tag paper when the thickness exceeds the specified value may affect the cutter life.
NOTE:
When using the Rotary Cutter, be sure to
install the Ribbon Saving Module (B-EX904-
R-QM-R). Failure to do this may cause a
paper jam or ribbon error.
NOTES:
1. Be sure to set the Selection Switch to
STANDARD/PEEL OFF
position.
2. The backing paper is easier to feed back to the Take-Up Spool if the Front Plate is removed.
3. Fit the Take-Up Clip so that the longer side of the clip is fitted into the shallow groove in the Take-Up
Spool.
4. The backing paper can be wound directly onto the Take-up Spool or a paper core.
Backing Paper
Strip Plate
Take-up Spool
Take-up Clip
Cutter Module
