30
INSTALLATION
3
Depending on locations of the bubble in the horizontal level
indicator, place caps and lock legs (Make sure to fix
adjustable legs.)
•
Mount the leg caps on the
right-hand legs. Rotate the
height adjust legs to
perform height adjustment.
4
Hold down the diagonal line of the washing machine and
make sure that no ratting occurs.
•
Despite the fact that the bubble is inside the circle, the ratting
exists. Then shaking motion
becomes larger or some
abnormal noise comes out.
Make sure to readjust in case
the washing machine rattles.
Leveling the washing machine
When adjusting the legs, supports the top of the machine. Do not support the machine bottom.
1
Adjust the legs so that the machine does not move.
Note: After adjustment, lock the nuts of
the legs by rotating them in the direc-
tion of the arrow. Make sure so that the
bottom of the main body front does not
reach the floor. If the bottom is in touch
with the floor, then it will be the cause
of shaking and abnormal noise.
2
Check the position of the air bubble in the floor level
indicator.
•
If the bubble is not positioned inside the circle, adjust the height
by rotating the leg caps.
Note: Check the floor level
indicator directly from above.
Standard point
Bubble
Tighten nuts of
adjustable legs
and lock them.
Height adjusting leg
Unlock
Lock
Up
Down
■
About the leg caps
The machine comes with four leg caps: two for adjustment in
steps of 3 mm and two for adjustment in steps of 6 mm. Use
them in combination as required. If they are to be stacked, posi-
tion the thicker caps under thinner ones.
(Ex.) The washing machine is
tilted towards the right.
Installing the drainage hose
Moving the hook
•
When inserting the drainage hose into a wash pan or
onto a drain pipe, the hook may be moved to facilitate
the installation.
•
When hooking the hose hook
into the slot provided on the
body of your washing machine,
move the hook back to its initial
position.
•
Insert the drainage hose in as far as it will go, then use the
accessory hose band to secure it tightly.
•
Secure the hose tightly. An improperly secured hose may
cause leakage.
•
Lock hose band distance to
cabinet about 10 mm as figure.
•
When attaching the drainage
hose to a wash pan, etc., either
leave a gap between the end of
the hose and the adjacent surface,
or cut the hose diagonally to ensure proper drainage
.
Allowing the flat end of the hose to come in contact
with the flat surface of the washing machine will
impair drainage.
Caution:
•
If the level of the threshold and the drainage hose is high, the
washing machine may not be drained.
•
Be careful not to rub the drainage hose. Do not insert the
drainage hose under the washing machine. They may be
damaged the drainage hose.
Drainage hose extension
•
Pay close attention to the height of the drainage hose and
articles over which it passes. If the drainage hose is too
high, proper drainage may not be obtained.
•
The length of the
drainage hose may be
extended to as much
as 3 m if kept the same
level.
3 m or less
Drainage hose cap
Hook
Drainage hose
15 cm or less
Drainage hose
Concrete block
Hose-band
Drain outlet
Drainage hose
10 mm
Gap
3 cm or
greater
Cut diagonally
Drainage hole
