Toro Z593-D Z Master 74264TE, Руководство оператора

Страница: 33 / 80

g027996
5
1
2
6
g027996
Figure 41
1. Full-width ramp in stowed
position 4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2. Side view of full-width
ramp in loading position 5. H=height of the trailer or
truck bed to the ground
3. Not greater than
15 degrees 6. Trailer
Using the Z Stand™
The Z Stand™ raises the front end of the machine to allow
you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and cause
serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand™.
• Use only for cleaning the mower and removing
the blades.
• Do not keep the machine on the Z Stand™ for
extended periods of time.
• Always turn the engine off, set the parking
brake, and remove the key before performing
any maintenance to the mower.
Driving up onto the Z Stand™
Important:
Use the Z Stand™ on a level surface.
1. Raise the mower to the T
RANSPORT
position.
2. Remove the bracket pin ( Figure 42 ).
g001811
Figure 42
1. Z Stand™ 4. Bracket pin
2. Latch 5. Bottom of slot
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(
Figure 42 and Figure 43 ).
4. Lengthen the Z Stand™ by removing the clevis pin
and hairpin cotter from the outer tube and sliding the
foot out.
5. Align the holes and install the clevis pin and hairpin
cotter pin.
33