Toro Z593-D Z Master 74264TE, Руководство оператора

Страница: 34 / 80

g001812
Figure 43
1. Z Stand™ (Positioned in
slot) 3. Latch resting on pivot tab
2. Crack in side walk or turf
6. Set the foot of stand on the ground and rest the latch
on the pivot tab (
Figure 43 ).
7. Start the engine and put it at half throttle.
Note:
For best results, place the foot of stand into
seams in sidewalks or into the turf ( Figure 43 ).
8. Drive onto the stand. Stop when the latch drops over
the tab into the L
OCKED
position ( Figure 43 ). Once
onto the stand, engage the parking brake and shut off
the engine.
9. Chock or block the drive wheels.
WARNING
The parking brake may not hold the machine
that is parked on the Z Stand™ and could
cause personal injury or property damage.
Do not park on the Z Stand™ unless wheels
are chocked or blocked.
10. Perform the maintenance on the machine.
Driving off the Z Stand™
1. Remove the chocks or blocks.
2. Raise the latch to the U
NLOCKED
position ( Figure 44 ).
g001813
Figure 44
1. Z Stand™ 3. L
OCKED
position
2. Latch 4. U
NLOCKED
position
3. Start the engine and place it at half throttle. Disengage
the parking brake.
4. Slowly drive backward off the stand.
5. Shorten the Z Stand™ by removing the clevis pin and
hairpin cotter pin from the outer tube and sliding the
foot in.
6. Align the holes and install the clevis pin and hairpin
cotter pin.
7. Return the stand to its R
EST
position ( Figure 42 ).
34