Toro Z Master G3, Руководство оператора

Страница: 56 / 68

G014940
Figure 85
1. Deck lift pedal 3. Transport lock
2. Height of cut pin
6. Insert the height adjustment pin into the 3 inch (7.6
cm) cutting height location.
7. Release the transport lock and allow the deck to
lower to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Postion A).
The measurement should read 3 inches (7.6 mm)
(Figure 86).
Figure 86
1. 3 inches (7.6 cm) at A is
correct 3. Measure here from the
blade tip to hard surface
2. 3 1/4 inches (8.3 cm) at B
is correct 4. Measure at A and B on
both sides
10. If needed, loosen the whizlock nut on the side of the
yoke and the jam nut on top. Fine tune the screw
adjuster by turning it to get 3 inch (7.6 mm) height
(see Figure 87).
To increase the height, turn the adjuster screw
clockwise; to decrease, turn counterclockwise.
Figure 87
1. Whizlock nut 3. Jam nut
2. Adjuster screw 4. Yoke
11. If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the two
bolts at the bottom of the height of cut plate. Refer
to Figure 88.
Figure 88
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck
is too high, loosen the single point adjustment bolt
by rotating it counterclockwise (Figure 89).
56