Toro Z Master Commercial 2000 74141TE, Руководство оператора

Страница: 22 / 60

Figure 24
Transport Lock Positions
1. Transport lock 3. Unlock position—does not
lock the mower deck into
transport position
2. Lock position—mower
deck will lock into transport
position
Adjusting the Height-of-Cut Pin
Mower deck size Height-of-cut
range Increments
48 inch
1-1/2 to 5 inches
(38 to 127 mm) 1/4 inch (6 mm)
The height-of-cut is adjusted by relocating the clevis pin into
different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 5-1/2
inch (140 mm) cutting height position) (Figure 25).
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket (Figure 25).
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and, insert the pin
(Figure 25).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
g017419
2
1
3
Figure 25
1. Deck lift pedal 3. Transport lock
2. Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
22