Toro Z Master 8000 Series, Руководство оператора

Страница: 57 / 68

Blade Maintenance
Blade Safety
•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades; never straighten or weld them.
•
On multi-bladed machines, take care as rotating
one blade can cause other blades to rotate.
•
Replace worn or damaged blades and bolts in sets
to preserve balance.
Servicing the Cutting
Blades
To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement,
you may want to keep extra blades on hand.
Before Inspecting or Servicing the
Blades
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
Inspecting the Blades
Service Interval: Before each use or daily
1. Inspect the cutting edges ( Figure 72 ).
2. If the edges are not sharp or have nicks, remove
and sharpen the blade; refer to
Sharpening the
Blades (page 58) .
3. Inspect the blades, especially in the curved area.
4. If you notice any cracks, wear, or a slot forming
in this area, immediately install a new blade
(
Figure 72 ).
g006530
Figure 72
1. Cutting edge 3. Wear/slot forming
2. Curved area 4. Crack
Checking for Bent Blades
1. Rotate the blades until the ends face forward
and backward.
2. Measure from a level surface to the cutting
edge, position
A , of the blades ( Figure 73 ).
g000975
Figure 73
1. Measure here from blade
to hard surface 2. Position A
3. Rotate the opposite ends of the blades forward.
4. Measure from a level surface to the cutting edge
of the blades at the same position as in step
2
above.
Note:
The difference between the dimensions
obtained in steps 2 and 4 must not exceed 3
mm (1/8 inch).
Note:
If this dimension exceeds 3 mm (1/8
inch), the blade is bent and must be replaced.
57