g015594
1
6 2
4
7
3
5
Figure 106
1.
Bolt
5.
Spring installed
2.
Spacer
6.
Grass Deflector
3.
Locknut
7.
J
hook end of spring
4.
Spring
2. Place spacer and spring onto grass deflector. Place
one
J
end of spring behind deck edge.
Note:
Make sure one
J
end of spring is installed
behind deck edge before installing the bolt as shown
in Figure 106.
3. Install bolt and nut. Place one
J
hook end of spring
around grass deflector (Figure 106).
Important:
The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
Cleaning
Cleaning Under the Mower
Service Interval:
Before each use or daily
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the transport position.
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
66
Содержание Z Master 74936
Страница 70: ...Schematics Wire Diagram Rev A 70...
Страница 71: ...Notes 71...
