Storage
Cleaning and Storage
1.
Disengage the power takeoff (blade-control
switch (PTO), engage the parking brake, and
turn the ignition key to the
OFF
position. Remove
the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps, and
motors.
3.
Check the brake; refer to
.
4.
Service the air cleaner; refer to
.
5.
Grease the machine; refer to
Lubrication (page
.
6.
Change the crankcase oil; refer to
Engine Oil (page 41)
.
7.
Check the tire pressure; refer to
Tire Pressure (page 50)
.
8.
Change the hydraulic filters; refer to
the Hydraulic Fluid and Filters (page 62)
.
9.
Charge the battery; refer to
(page 46)
.
10.
Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
11.
Check the condition of the blades; refer to
Servicing the Cutting Blades (page 65)
.
12.
Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows:
A.
Add a petroleum based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol-based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
B.
Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C.
Shut off the engine, allow it to cool, and
drain the fuel tank; refer to
in the Maintenance
Section.
D.
Start the engine and run it until it stops.
E.
Dispose of fuel properly. Recycle according
to local codes.
Important:
Do not store
stabilizer/conditioned fuel over
90 days.
13.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
15.
Store the machine in a clean, dry garage or
storage area.
16.
Remove the key from the ignition switch
and keep it out of reach of children or other
unauthorized users.
17.
Cover the machine to protect it and keep it clean.
70
Содержание Z Master 74926
Страница 75: ...Notes...
