Toro Z Master 74926, Руководство оператора

Страница: 64 / 76

g009196
Figure 94
1. 7.6 cm (3 inch) at position
A is correct 3. Measure here from the
blade tip to the hard
surface
2. 8.3 cm (3-1/4 inch) at
position B is correct 4. Measure at position A and
B on both sides
10. Fine-tune the adjustment nut on the front deck
lift assembly by turning it (
Figure 95 ).
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease, turn
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, the
single-point adjustment can be utilized to gain
more adjustment.
g027344
Figure 95
1. Adjustment nut 3. Rear deck adjustment
2. Jam nut 4. Front deck adjustment
11. To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(
Figure 96 ).
g027345
Figure 96
1. Bolts at the bottom of the height-of-cut plate
12. If the deck is too low, tighten the
single-point-adjustment bolt by rotating it
clockwise. If the deck is too high, loosen
the single-point-adjustment bolt by rotating it
counterclockwise (
Figure 97 ).
64