Toro Z Master 74926, Руководство оператора

Страница: 50 / 76

Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
EUTRAL
-L
OCK
position.
3. Move the throttle midway between fast and slow.
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
•
If it tracks to the right, loosen the bolts and
adjust the left stop plate rearward on the
left T-slot until the machine tracks straight
(
Figure 67 ).
•
If it tracks to the left, loosen the bolts and
adjust the right stop plate rearward on the
right T-slot until the machine tracks straight
(
Figure 67 ).
6. Tighten the stop plate ( Figure 67 ).
g027340
Figure 67
Left control lever shown
1. Control lever 3. Stop plate
2. Bolt
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the front and rear tires at
90 kPa (13 psi). Uneven tire pressure can cause an
uneven cut. Check the tires when they are cold to get
the most accurate pressure reading.
g001055
Figure 68
Checking the Wheel-Lug
Nuts
Check and torque the wheel lug nuts to 122 to 129
N∙m (90 to 95 ft-lb).
Checking the Wheel-Hub
Slotted Nut
Service Interval: After the first 100 hours
Every 500 hours
Check and ensure that the torque of the slotted nut is
286 to 352 N∙m (211 to 260 ft-lb).
Note:
Do not use anti-seize compound on wheel hub.
50