Toro Workman 3000 Series, Руководство по обслуживанию

Страница: 35 / 306

Removal (Fig. 10)
1. Put vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder (see
Operator’s Manual).
3. Remove exhaust system components as needed us-
ing Figure 10 as a guide.
4. Discard gaskets and thoroughly clean flange sur-
faces of manifold and muffler.
Installation (Fig. 10)
1. Replace any removed gaskets.
2. If cap screw (item 9) was removed, apply Loctite
#242 (or equivalent) to threads during installation.
3. Using Figure 10 as a guide, fit all exhaust compo-
nents to vehicle before tightening any fasteners. When
securing exhaust, tighten fasteners in the following or-
der:
A. Hex nuts (item 4) that secure exhaust manifold to
engine.
B. Cap screw (item 9) with washer (item 10) that se-
cures muffler to transaxle.
C. Socket head screws (item 6) and flange nuts
(item 8) that secure muffler to manifold.
D. Cap screws (item 7) and flange nuts (item 11) that
secure muffler to shift cable mount bracket.
E. Carriage bolts (item 12) and flange nuts (item 11)
that secure muffler to mount plate.
4. Lower or install bed or attachment(s).
Briggs/Daihatsu
Gasoline Engine
Workman 3200/4200
Page 3 – 15
Briggs/Daihatsu Gasoline Engine