Toro Workman 07223-90001, Каталог оператора, настройки и запасных частей

Страница: 2 / 12

2
1
1
SAFETY INSTRUCTIONS
BED REMOVAL PROCEDURE :
6. For removal of the cargo bed to preform engine
service, adhere to the following procedure:
A. Stop the Vehicle and set the parking brake.
B. Shut off the vehicle’s engine and remove
key from ignition.
WHILE OPERATING:
3. Always follow Workman
®
Vehicle operating
instructions in Workman
®
Vehicle Operator’s
Manual.
4 . DO NOT OVERLOAD THE VEHICLE. Never
exceed maximum Operator and Pay Load
Capacity of 1800 lb and maximum Gross Vehicle
Weight of 4000 lb. Failure to position loads
carefully can result in their shifting or tipping over.
Distribute loads evenly, as low as possible, with
center of gravity forward of rear axle. Secure load
using Lifting Lugs (Figure 3).
5 . Make certain everyone is clear of the machine
before loading or starting the engine to move the
vehicle.
6 . Before backing up, look to the rear and assure
no one is behind. Back up slowly .
C. Disengage all power and wait until all
moving parts have stopped.
D . Remove all cargo.
E . Remove welding gas bottles (if equipped)
F . Remove bed’s Front Securing Bolts,
shown in Figure 1.
G . Remove Rear Securing Pins, shown in
Figure 2.
FIG. 1
1. Front Securing Bolt
FIG. 2
1. Rear Securing Pin
Base Weight for Bed of Industrial
Workman
®
kit is 350 lb.
Always be sure Lifting device is capable
of lifting bed and any attached accessory
to avoid personal injury or death.
WARNING
H . Lift the cargo bed from four corners evenly
from the vehicle’s frame, using Lifting
Lugs as shown in Figure 3, and set aside.
Do not exceed capacity. Maximum
capacity of operators, attachments and
cargo is 1800 LB (4000 LB. GVW)
or 800Kg (1800Kg GVW).
Always distribute cargo load evenly on
bed with center of gravity of load forward
of rear axle.
WARNING