Maintenance
23
6.
Remove rear idler and replace belt (Fig. 40).
Install rear idler.
7.
Install belt covers on tractor and snowthrower
(Fig. 38),
m–2769
1
3
2
Figure 40
1.
Outer groove of (PTO)
power take off
2.
Rear idler pulley
3.
Snowthrower pulley
Storage
1.
Before long term storage wash the machine with
mild detergent and water to remove dirt and
grime from the entire machine.
2.
Check the condition of the scraper blade; refer to
Reversing Scraper Blade, page 21.
3.
Check the condition of the drive belt and chain.
4.
Grease and oil the snowthrower; refer to
Greasing and Lubrication, page 20.
5.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged or
defective.
6.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
7.
Coat inside auger housing and discharge chute
with automotive wax to prevent rust and reduce
the sticking of snow to these surfaces.
8.
Store the machine in a clean, dry garage or
storage area. Cover the machine to protect it and
keep it clean.
