Toro Wheel Horse 520xi, Руководство оператора

Страница: 18 / 44

18
m–3312
1
Figure 22
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 23).
2. Move the steering wheel to a comfortable position;
then release the lever to lock it in place.
1
2
m–3259
Figure 23
1. Tilt lever 2. Steering wheel
Centering the Steering Wheel
(Power Steering Models)
The power steering may not always return the steering
wheel to the centered position when you turn the wheels
straight forward. If this happens, center the steering wheel
using the following procedure:
1. Note the degree to which the steering wheel is out of
center.
2. Turn the steering wheel all the way in the opposite
direction until the front wheels no longer turn.
3. Continue turning the steering wheel by the degree to
which it is off center.
4. Turn the steering wheel in the other direction until the
front wheels aim straight ahead.
The steering wheel should now be centered.
The Smart Turn Steering
Feature
The Smart Turn Steering feature automatically lowers
the speed of the tractor in tight turns. The decrease in
speed is directly proportional to the sharpness of the turn,
up to a maximum speed reduction of 40 percent. This
allows you to make turns at higher speeds without having
to change the speed control position. After the turn, the
original speed is automatically restored.
The Smart Turn Steering feature does not affect engine
speed.
This system was set at the factory and should not need
adjustment.
Danger
Driving with excessive speed while turning can
cause you to rollover, resulting in serious injury or
death to you or bystanders.
•
Do not rely on the Smart Turn steering feature
to avoid accidents while turning.
•
Read, understand, and follow all instructions in
the Operator’s Manual and on the machine
before starting.
Pushing the Machine by Hand
Important
Do not tow the machine because
transmission damage may occur. Always push the
machine by hand.
1. Disengage the PTO and stop the engine.
2. Move the High-Low range lever to the neutral position
(N).
This allows the rear wheels to turn freely.
3. Push the machine to the desired location.
4. Place the lever high or low after moving the machine,
and set the parking brake.