Toro wheel horse 518XI, Руководство оператора

Страница: 41 / 52

Maintenance
39
Installing the Bulb
1. The bulb has metal pins on the side of its base.
Align the pins with the slots in the bulb holder
and insert the base into the holder (Fig. 51).
Push and rotate the bulb clockwise until it stops.
1
2
3
4
2
4
Figure 51
1. Bulb
2. Metal pins
3. Bulb holder
4. Slots
2. The bulb holder has two tabs (Fig. 50). Align the
tabs with the slots in the reflector, insert the bulb
holder into the reflector and rotate it 1/4 turn
clockwise until it stops.
3. Push the wire connectors onto the terminals on
the bulb holder.
Battery
Service Interval/Specification
Check the electrolyte level in the battery every 25
hours. Always keep the battery clean and fully
charged. Use a paper towel to clean the battery case.
If the battery terminals are corroded, clean them with
a solution of four parts water and one part baking
soda. Apply a light coating of grease to the battery
terminals to prevent corrosion.
Battery size: 12 v, 380 Cold Cranking Amps
Checking the Electrolyte Level
1. Park the machine on a level surface. Disengage
the power take off (PTO), set the parking brake,
lower the attachment lift, and turn the ignition
key to “STOP” to stop the engine. Remove the
ignition key.
2. Remove the front grille by pulling it outward
toward you.
3. Remove the battery shield.
4. Open the cell covers to see into the cells. The
electrolyte must be up to the lower part of the
tube (Fig. 52). Do not allow the electrolyte to get
below the plates.
5. If the electrolyte is low, add the required amount
of distilled water; refer to Adding Water to the
Battery.
6. If the fluid level is correct, press the cell covers
onto the battery and replace the battery shield.
IMPORTANT: Keep the battery shield in
place to protect the battery from heat.
7. Replace the grille.
1
Figure 52
1. Lower part of the battery
cell tube