Toro wheel horse 518XI, Руководство оператора

Страница: 39 / 52

Maintenance
37
2. Park the machine on a level surface to assure the
oil drains completely. Then turn off the power
take off (PTO), set the parking brake, lower the
attachment lift, and turn the ignition key to
“STOP” to stop the engine. Remove the ignition
key.
3. Place a pan below the transaxle drain. Open the
drain by removing the plug (Fig. 47).
4. When the oil has drained completely, install the
plug.
Note: Dispose of the used oil at a certified
recycling center.
1
m–3322
Figure 47
1. Transaxle drain plug
5. Change the transaxle filter; refer to Changing the
Transaxle Filter, page 37.
6. Slowly pour the specified refill capacity of oil
into the filler tube (Fig. 45).
7. Start the engine, let it run for 30 seconds at high
idle, and cycle the steering wheel several times
(power steering models only) to fill the filter and
hydraulic lines. Then shut off the engine.
8. Now check the fluid level; refer to Checking
Transaxle Fluid Level, page 36. Slowly add
additional oil to bring the oil level to the FULL
mark on the dipstick.
Changing the Transaxle Filter
Service Interval/Specification
Replace the transaxle filter after the first 50 hours;
then every 200 hours.
1. Drain the oil from the transaxle; refer to
Changing/Draining Transaxle Fluid, page 36.
2. Remove the transaxle filter and wipe the filter
adapter (Fig. 48) gasket surface.
3. Apply a thin coat of new oil to the rubber gasket
on the replacement filter (Fig. 48).
1256
1
2
3
Figure 48
1. Transaxle filter
2. Gasket
3. Adapter