10
1
Figure 11
1.
Drive shield
2. On back side of frame, loosen capscrew securing belt
tensioner to frame (Fig. 12).
1
2
3
4
Figure 12
1.
Tensioner guide
2.
Capscrew & nut
3.
Capscrew (back of frame)
4.
Tensioner
3. Remove capscrew and nut securing tensioner guide to
drive mount (Fig. 12). Belt tension will be released
when capscrew is removed.
4. Position a large wrench on tensioner. Rotate tensioner
clockwise until decal arrow is aligned with 15
on
tensioner tube.
5. Insert capscrew into aligned guide holes and secure
with nut. If holes are not exactly aligned, rotate guide to
the next higher hole until aligned.
6. Tighten capscrew, on back side of frame to lock
tensioner.
7. Install the motor shield with the fasteners previously
removed.
Replacing Finger Belts
1. Loosen nuts and washers securing finger pinchers to
rotor (Fig. 13).
2. Remove old belt fingers.
3. Install new belt fingers. Belt fingers to extend from
finger pinchers approximately 4 inches.
4. Tighten nuts securing assembly.
1
3
2
Figure 13
1.
Finger pincher
2.
Rotor
3.
Belt finger
Replacing Flail Knives
When flail knife edges become curved from wear, they
should be reversed or replaced.
1. Remove roll pin securing mounting pin to flail rotor
(Fig. 14).
2. Slide mounting pin from rotor allowing removal of flail
knives and spacers (Fig. 14).
