Toro TurfMaster HDX, Руководство оператора

Страница: 32 / 40

10. Rotate the idler pulley over the access hole on
the transmission by using a socket wrench to
turn the idler-pulley nut.
g281194
Figure 48
1. Socket wrench 3. Access hole
2. Idler-pulley nut 4. Screwdriver
11. While you are holding the idler pulley over
the access hole on the transmission, insert a
screwdriver through the access hole to catch a
rib on the idler pulley.
g280736
Figure 49
1. Screwdriver through
access hole 3. Idler pulley
2. Access hole 4. Transmission belt
12. Use the screwdriver to hold the idler pulley out
of the way until you are done installing the new
transmission belt.
13. Remove the hex-head bolt and carriage bolt that
are holding the transmission bracket onto the
frame (
Figure 50 ).
g280656
Figure 50
1. Transmission bracket 3. Hex-head bolt
2. Carriage bolt
14. Allow the transmission to swing down.
Note:
If the traction cable is pulled too tight,
damage may occur. Ensure that the traction
cable is not pulled tight.
15. Remove the transmission belt.
Installing the Transmission Belt
1. While the idler pulley is pulled out of the way,
install the new transmission belt.
2. Use the hex-head bolt and carriage bolt,
removed in Step
13 of Removing the
Transmission Belt (page 31) to secure the
transmission bracket onto the frame.
3. Remove the screwdriver from the access hole in
the transmission to return the idler pulley to its
tensioned position.
4. Use the rear-viewing window, located under the
rear-discharge deflector, to ensure that the new
transmission belt is positioned correctly.
5. Install the trailing shield using the 2
trailing-shield bolts removed in Step
9 of
Removing the Transmission Belt (page 31) .
6. Install the rear-viewing window, located
under the rear-discharge deflector, using the
corresponding bolt removed in
8 of Removing
the Transmission Belt (page 31) .
32