Toro TITAN 74861, Руководство оператора

Страница: 53 / 60

WARNING
A broken or missing washout fitting
could expose you and others to thrown
objects or blade contact. Contact with
blade or thrown debris can cause injury
or death.
• Replace broken or missing washout
fitting immediately, before using
mower again.
• Never put your hands or feet under
the mower or through openings in the
mower.
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
Storage
Cleaning and Storage
1. Disengage the blade control switch (PTO), set
the parking brake, and turn the ignition key to
Off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
under the seat, around the engine, hydraulic
pumps, and motors.
3. Check the parking brake operation; refer to
Operating the Parking Brake (page 19) .
4. Service the air cleaner; refer to Servicing the Air
Cleaner (page 32) .
5. Grease the machine; refer to Greasing the
Bearings (page 31) .
6. Change the crankcase oil; refer to Servicing the
Engine Oil (page 33) .
7. Check the tire pressure; refer to Checking the
Tire Pressure (page 40) .
8. Change the hydraulic filter; refer to Changing
the Hydraulic System Filter and Oil (page 41) .
9. Charge the battery; refer to Charging the Battery
(page 39) .
10. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
11. Check the condition of the blades; refer to
Servicing the Cutting Blades (page 44) .
12. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows:
A. Add a petroleum based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
53