decal130-6996
Figure 31
Located on the seat pan underside
1.
Read the
Operator's Manual
for information on maintenance.
4.
Check the hydraulic oil every 25 hours
2.
Check the engine oil every 8 hours
5.
Check the caster wheel tire pressure every 25 hours
3.
Check the drive wheel tire pressure every 25 hours
6.
Lubricate the caster wheel every 25 hours
Pre-Maintenance
Procedures
Raising the Seat
Make sure the motion control levers are locked in the
neutral lock position. Lift the seat forward.
The following components can be accessed by raising
the seat:
•
Service decal
•
Fuses
•
Battery and cables
Lubrication
Greasing the Bearings
Service Interval:
Every 25 hours—Grease all
lubrication points.
Grease Type:
No. 2 General Purpose Lithium Base
Grease
1.
Park the machine on a level surface and
disengage the blade control switch.
2.
Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, and wait for all moving parts to stop
before leaving the operating position.
3.
Clean the grease fittings with a rag (
and
). Make sure to scrape any paint
off of the front of the fitting(s).
31
Содержание TITAN 74861
Страница 57: ...Schematics g028048 Wire Diagram Rev A 57...
Страница 58: ...Notes...
Страница 59: ...Notes...
