Toro TITAN 74861, Руководство оператора

Страница: 39 / 60

Installing the Battery
1. Position the battery in the tray with the terminal
posts opposite from the fuel tank (
Figure 44 ).
2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative battery (black) cable to the
negative (-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and
2 locknuts (
Figure 44 ).
5. Slide the red terminal boot onto the positive
(red) battery post.
6. Install the clamp and secure it with the wing nut
(
Figure 44 ).
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery, and keep
sparks and flames away from battery.
Important:
Always keep the battery fully charged.
This is especially important to prevent battery
damage when the temperature is below 32°F (0°C).
1. Charge the battery for 10 to 15 minutes at 25 to
30 amps or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (
Figure 45 ).
3. Install the battery in the machine and connect
the battery cables, refer to Installing the Battery.
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
g000960
Figure 45
1. Positive battery post 3. Red (+) charger lead
2. Negative battery post 4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however if a fuse blows, check the
component/circuit for a malfunction or short.
Note:
The fuses are located on right hand console
next to the seat ( Figure 46 ).
Fuses:
•
Main, 30 amp, blade-type
•
Engine, 20 amp, blade-type
1. To replace the main fuse, grasp the fuse and pull
it straight and away from the fuse block.
39