Toro TITAN 74861, Руководство оператора

Страница: 47 / 60

2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, set the parking brake and wait for
all moving parts to stop before leaving the
operating position.
3. Carefully rotate the blades side to side.
4. Measure between the outside cutting edges and
the flat surface (
Figure 61 ).
Note:
If both measurements are not within
5 mm (3/16 inch), an adjustment is required;
continue to the Leveling procedure.
g007202
Figure 61
1. Blades side to side
3. Measure from the tip of the
blade to the flat surface
here
2. Outside cutting edges
Checking the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
7.9 mm (5/16 inch) lower than the rear of the mower,
adjust the blade level using the following instructions:
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
neutral position, engage the parking brake,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Carefully rotate the blades so they are facing
front to rear (
Figure 62 ).
4. Measure from the tip of the front blade to the
flat surface and the tip of the rear blade to the
flat surface (
Figure 62 ).
Note:
If the front blade tip is not 1.6-7.9 mm
(1/16-5/16 inch) lower than the rear blade
tip, continue to the Leveling the Mower Deck
procedure.
g007199
Figure 62
1. Blades front to rear 3. Measure from the tip of the
blade to the flat surface
here
2. Outside cutting edges
Leveling the Mower Deck
1. Set anti-scalp rollers to top holes or remove
completely for this procedure; refer to
Adjusting
the Anti-Scalp Rollers (page 24) .
2. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
Adjusting the Height-of-Cut
(page 23) .
3. Place two 6.66 cm (2-5/8 inch) blocks under
each side of the front edge of the deck, but not
under the anti-scalp roller brackets (
Figure 63 ).
4. Place two 7.30 cm (2-7/8 inch) thick blocks
under the rear edge of the cutting deck skirt; one
on each side of the cutting deck (
Figure 63 ).
g024428
Figure 63
1. Wood block, 6.66 cm
(2-5/8 inch) thick 3. Front edge
2. Wood block, 7.30 cm
(2-7/8 inch) thick
5. Loosen the adjustment bolts on all four corners
so that the deck is sitting securely on all four
blocks (
Figure 64 ).
47