Toro Titan 280000001, Инструкция по эксплуатации

Страница: 2 / 20

Never operate the engine with the oil level below the
“L” mark or over the “F” mark on the dipstick.
Changing the Oil and Filter
Service Interval: Every 100 hours/Yearly (whichever
comes first) (more frequently under
extremely dusty, dirty conditions).
Change the oil and filter while the engine is still warm.
The oil will flow more freely and carry away more
impurities. Make sure the engine is level when filling,
checking, or changing the oil.
1. Start the engine and let it run until warm. This
warms the oil so it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
3. Disengage the blade control switch and move the
motion controls outward to the neutral position and
engage parking brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Clean the area around the drain plug and on the
machine frame. Place a pan underneath machine
directly below the drain hole in the frame as shown
in Figure 3
Figure 3
1. Oil drain hose
3. Pan
2. Oil drain plug
6. Remove the oil drain plug (Figure 3). Remove the oil
fill cap/dipstick (Figure 2).
Figure 4
1. Oil filter 2. Gasket
7. Be sure to allow ample time for complete drainage.
8. Remove the old filter and wipe off the mounting pad
(Figure 4).
9. When the oil has drained completely, install the
oil drain plug. Tighten the plug to 14 N-m (125
in-lb) torque. Wipe up any excess oil on the frame
(Figure 3).
Note:
Dispose of the used oil at a recycling center.
10. Apply a thin film of clean oil to the rubber gasket on
the new filter.
11. Install the replacement oil filter to the mounting pad.
Turn the oil filter clockwise until the rubber gasket
contacts the pad, then tighten the filter an additional
1/2 to 3/4 turn (Figure 3).
12. Slowly pour approximately 80% of the specified oil
into the filler tube.
13. Install the oil fill cap/dipstick and push firmly into
place.
14. Check the oil level (Figure 2); refer to the Checking
the Oil Level section.
15. Slowly add additional oil to bring it to the full mark.
16. Install the oil fill cap/dipstick and push firmly into
place.
2