Toro TimeMaster 20199, Руководство оператора

Страница: 7 / 84

Figure 7
1. The oil level is too low;
add oil to the crankcase. 3. The oil level is correct.
2. The oil level is too high;
remove oil from the
crankcase.
•
If the oil level is too low, slowly pour a small
amount of oil into the oil-fill tube, wait 3 minutes,
and repeat steps 3 through 5 until the oil level on
the dipstick is correct as shown in Figure 7.
•
If the oil level is too high, drain the excess
oil until you obtain the correct oil level on
the dipstick. To drain the excess oil, refer to
Changing the Engine Oil (page 16).
Important:
If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely.
Important:
Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page 16).
4
Charging the Battery
No Parts Required
Procedure
Electric-start model only
Refer to Charging the Battery (page 17).
Product Overview
2
14
1
13
3
4
5
6
7
8
9
10
1 1
12
g016439
15
16
Figure 8
1. Side-discharge deflector 9. Ignition switch
(electric-start model only)
or toggle switch (standard
model only)
2. Spark plug 10. Battery (electric-start
model only; not shown)
3. Oil fill/dipstick (not shown) 11. Rear cutting-height lever
4. Recoil-start handle 12. Rear-discharge deflector
5. Fuel-tank cap 13. Fuse
6. Handle-lock lever 14. Air filter
7. Handle knob (2) 15. Washout port
8. Upper handle 16. Front cutting-height lever
7