Toro TimeMaster 20199, Руководство оператора

Страница: 15 / 84

•
Be aware of a potential fire hazard in very dry conditions,
follow all local fire warnings, and keep the machine free
of dry grass and leaf debris.
•
Alternate the mowing direction. This helps disperse the
clippings over the lawn for even fertilization.
•
If the finished lawn appearance is unsatisfactory, try one
or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full swath
with each pass.
– Set the cutting height on the front wheels one notch
lower than the rear wheels. For example, set the front
wheels at 2-inch (51 mm) and the rear wheels at 2-1/2
inches (64 mm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn shows
through the cut leaf cover. You may need to make more
than one pass over the leaves.
•
If there are more than 5 inches (13 cm) of leaves on the
lawn, set the front cutting height 1 or 2 notches higher
than the rear cutting height.
•
Slow down your mowing speed if the machine does not
cut the leaves finely enough.
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours
• Change the engine oil.
Before each use or daily
• Check the engine oil level.
• Check the blade-brake-clutch operation.
• Check the air cleaner and clean or replace it, if necessary.
• Check the cutting blades.
• Clean grass clippings and dirt from under the machine housing.
Every 25 hours
• Charge the battery (electric-start model only).
Every 50 hours
• Change the engine oil.
• Service the blade-drive system.
Yearly
• Service the air filter; replace it more frequently in dusty operating conditions.
• Change the engine oil.
• Service the cutting blades.
• Refer to your engine operator's manual for any additional yearly maintenance
procedures.
Yearly or before storage
• Charge the battery (electric-start model only).
• Empty the fuel tank before repairs as directed and before yearly storage.
Important:
Refer to your engine operator's manual for additional maintenance procedures.
15