Toro TimeMaster 20199, Руководство оператора

Страница: 21 / 84

Checking for Bent Blades
1. Rotate the blades to the position shown in Figure 42.
B
B
2
1
3
g016532
Figure 42
1. Front of cutting deck 3. Measure from the cutting
edge to a smooth, level
surface
2. Measure at locations A
and B
2. Measure from a level surface to the cutting edges
at locations
A and B (Figure 42), and record both
dimensions.
3. Rotate the blades so that their opposite ends are at
locations
A and B (Figure 42).
4. Repeat the measurements in step 2 and record them.
Note:
If the difference between the dimensions A
and B obtained in steps 2 and 4 exceeds 1/8 in (3
mm), the blade is bent and you will need to replace
it. Refer to Removing the Blades (page 21) and
Installing the Blades (page 22).
WARNING
A blade that is bent or damaged could break apart
and could seriously injure or kill you or bystanders.
• Always replace a bent or damaged blade with
a new blade.
• Never file or create sharp notches in the edges
or surfaces of a blade.
Removing the Blades
Replace the blades when the machine hits a solid object or
when a blade is out of balance or bent. Use only genuine
Toro replacement blades.
1. Use a block of wood to hold each blade steady and turn
the blade bolt counterclockwise as shown in Figure 43.
Figure 43
2. Remove each blade as shown in Figure 44.
G016530
1
2
3
4
Figure 44
1. Spindle (2) 3. Blade (2)
2. Blade driver (2) 4. Blade bolt (2)
3. Inspect the pins on the blade drivers for wear and
damage.
21