Toro TimeCutter ZD420T, Руководство оператора

Страница: 26 / 48

G010222
2
1
3
Figure 28
1. Rear access panel 3. Frame
2. Fastener
Installing the Engine Hood
1. To install the hood, align the slot in the hood with
the frame and carefully lower it onto the frame
(Figure 29). Make sure the frame seated correctly
in the engine hood groove before forcing the hood
down. Push down gently to seat the retaining pin.
Replace the fasteners removed previously.
G005886
1
2
3
4
Figure 29
1. Engine hood 3. Frame mating with slot in
the hood.
2. Frame 4. Fastners
2. Install the collection bag; refer to
Operation (page 13).
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours
Grease the front caster pivots and wheels (Figure 30).
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings (Figure 30 and Figure 31)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
Figure 30
1. Front caster tire
Figure 31
4. Connect a grease gun to each fitting (Figure 30 and
Figure 31). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
26