Toro TimeCutter Z480, Руководство оператора

Страница: 28 / 44

2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative battery cable to the negative
(-) battery terminal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inch),
washers (1/4 inch), and wing nuts (1/4 inch)
(Figure 32).
5. Slide the red terminal boot onto the positive
(red) battery post.
6. Secure the battery with the hold-down
(Figure 32).
Servicing the Fuses
The electrical system is protected by fuses. It
requires no maintenance; however, if a fuse blows,
check the component/circuit for a malfunction
or short.
Fuse:
• Main F1-30 amp, blade-type
• Charge Circuit F2-25 amp, blade-type
• Optional Headlight Kit-10 amp, blade type
1. Raise the seat to gain access to the fuse holder
(Figure 34).
2. To replace a fuse, pull out on the fuse to
remove it (Figure 34).
Figure 34
1. Main-30 amp 3. For optional Headlight
Kit-10 amp
2. Charge circuit-25 amp 4. Battery
Drive System
Maintenance
Checking the Tire Pressure
Maintain the air pressure in the front and rear
tires as specified. Uneven tire pressure can cause
uneven cut. Check the pressure at the valve
stem after every 50 operating hours or monthly,
whichever occurs first (Figure 35). Check the
tires when they are cold to get the most accurate
pressure reading.
Rear Tires: 13 psi (90 kPa)
Front Tires (castor wheels): 35 psi (139 kPa)
Figure 35
1. Valve stem
Mower Maintenance
Servicing the Cutting Blades
Maintain sharp blades throughout the cutting
season because sharp blades cut cleanly without
tearing or shredding the grass blades. Tearing and
shredding turns grass brown at the edges, which
slows growth and increases the chance of disease.
Check the cutter blades daily for sharpness, and
for any wear or damage. File down any nicks
and sharpen the blades as necessary. If a blade is
damaged or worn, replace it immediately with a
genuine Toro replacement blade. For convenient
sharpening and replacement, you may want to
keep extra blades on hand.
28