Toro TimeCutter Z480, Руководство оператора

Страница: 23 / 44

Servicing the Engine Oil
Check the oil level daily or after every 8 hours.
Change the oil after the first 5 operating hours and
every 50 operating hours thereafter.
Oil Type: Detergent oil (API service SF, SG, SH,
SJ, or higher)
Crankcase Capacity:
• 48 oz./1-1/2 qt. (1400 cc/1.4 l) when the filter
is not changed;
• 56 oz./1-3/4 qt. (1700 cc/1.7 l) when the filter
is changed
Viscosity: See the table below.
Figure 23
Checking the Oil Level
1. Park the machine on a level surface, disengage
the blade control switch, stop the engine, and
remove the key.
2. Clean around the oil dipstick (Figure 24) so
that dirt cannot fall into the fill hole and
damage the engine.
Figure 24
1. Oil dipstick 3. Oil drain valve
2. Filler tube
3. Unscrew the oil dipstick and wipe the end
clean (Figure 25).
Figure 25
1. Oil dipstick 2. Metal end
4. Screw the oil dipstick fully onto the fill hole.
Unscrew the dipstick, pull it out, and look at
the end. If the oil level is low, slowly pour only
enough oil into the fill hole to raise the level to,
but not over, the Full mark on the dipstick.
Important:
Do not overfill the crankcase
with oil because the engine may be
damaged.
Changing the Oil
1. Start the engine and let it run until warm. This
warms the oil so it drains better.
2. Park the machine so that the drain side is
slightly lower than the opposite side to assure
the oil drains completely.
3. Disengage the blade control switch and set the
parking brake.
4. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
23