Toro TimeCutter 74502, Руководство оператора

Страница: 20 / 40

20
Servicing the Engine Oil
Check the oil level daily or after every 8 hours.
Change the oil after the first 5 operating hours and every 50
operating hours thereafter.
Oil Type: Detergent oil (API service SF, SG, SH, SJ, or
higher)
Crankcase Capacity: 48 oz./1-1/2 qt. (1400 cc/1.4 l) when
the filter is not changed; 56 oz./1-3/4 qt.
(1700 cc/1.7 l) when the filter is changed
Viscosity: See the table below.
F
–20 0 20 40 60 80 100
°
C
–30
°
–20 –10 0 10 20 30 40
USE THESE SAE VISCOSITY OILS
Checking the Oil Level
1. Park the machine on a level surface, disengage the PTO,
stop the engine, and remove the key.
2. Clean around the oil dipstick (Fig. 15) so that dirt
cannot fall into the fill hole and damage the engine.
1
Figure 15
1. Oil dipstick
3. Unscrew the oil dipstick and wipe the metal end clean
(Fig. 16).
1
2
1868
Figure 16
1. Oil dipstick 2. Metal end
4. Screw the oil dipstick fully onto the fill hole. Unscrew
the dipstick, pull it out, and look at the metal end. If the
oil level is low, slowly pour only enough oil into the fill
hole to raise the level to, but not over, the Full mark on
the dipstick.
Important
Do not overfill the crankcase with oil
because the engine may be damaged.
Changing and Draining the Oil
1. Start the engine and let it run for five minutes. This
warms the oil so that it drains better.
2. Park the machine so that the drain side is slightly lower
than the opposite side to ensure that the oil drains
completely. Then disengage the PTO, set the parking
brake, stop the engine, and remove the ignition key.
3. Place a pan below the oil drain pipe and remove the
drain cap (Fig. 17).
1
2
m–5181
Figure 17
1. Oil drain cap 2. Oil dipstick/fill tube
4. When the oil has drained completely, install the drain
cap.
Note: Dispose of the used oil at a certified recycling center.
5. Change the oil filter, if necessary (Fig. 18).
6. Clean around the oil dipstick and unscrew the cap
(Fig. 15).