TDC+ QUICK START GUIDE
Page 13
/ 20
Assigning Control Module Serial Port & Completing Setup
This procedure will designate which serial communication port on the TDC+ Control Module
will talk to the Two-Wire Gateway (output boards). On a TDC+, it is recommended that you
designate and utilize the “front” serial port, because computer programming occurs through the
“back port”.
8.
Choose the
Advanced
tab.
9.
Under Station Type / port assignments: For “Send Toro 2-Wire commands to:” select
Serial
Port 1 (front port)
.
10.
Under “Station Types allowed after 96,” select
Toro 2-wire
.
11.
SAVE
all Changes and Close Special Data Window.
